Zephyrproject Zephyr: Integer Underflow (Wrap or Wraparound) (CVE-2026-75083)
Published Last modified Sources: CVE.org
What is affected, what to do
The receive path of the NXP KW41Z IEEE 802.15.4 driver, kw41z_rx() in drivers/ieee802154/ieee802154_kw41z.c, computed the payload size as pkt_len = len - KW41Z_FCS_LENGTH in a uint8_t, where len is the frame length reported by the radio. The interrupt handler kw41z_isr() obtained that length from the RX_FRAME_LENGTH field of the ZLL IRQSTS register — a copy of the PHY header length byte of the frame received over the air — and only rejected the value zero.
Update Zephyrproject Zephyr to version 4.3.2, Zephyrproject Zephyr to version 4.5.0.
- Affected
- Zephyrproject Zephyr
lt 1.8.0..4.3.2 - Zephyrproject Zephyr
lt 4.4.0..4.5.0
- Zephyrproject Zephyr
- Fixed in
- Zephyrproject Zephyr
4.3.2 - Zephyrproject Zephyr
4.5.0
- Zephyrproject Zephyr
Not sure whether and how you are affected? Ask a question about this vulnerability
Metrics
5.9
Priority
XIEM Effective CVSS: highest available CVSS rating from NVD and vendor data.
Source: Vendor (CNA), CVSS v3
5.9
CVSS v3
Severity Medium on the scale from 0 to 10.
Source: CVE.org
0.2 %
EPSS score
Low — model estimates < 1% exploitation likelihood.
Source: FIRST EPSS, percentile 13.9
Show all metrics
- Severity
- Medium
Priority (0–325)
The priority score is a consolidated metric that condenses several individual signals into a single, action-guiding ranking: technical severity (CVSS), exploitation likelihood (EPSS), known-exploited status (KEV) and the context of the affected asset. The aim is to answer the only truly important question in vulnerability management: what first?
Read in glossary- 61.04 Methodology
Exploit maturity
An exploit is code or a technique that specifically uses a concrete vulnerability to force unintended behaviour — such as executing code or escalating privileges. It is the tool that turns a theoretical flaw into a practical attack.
Read in glossary- no public PoC known
XIEM Effective CVSS
XIEM® is the tiered managed-security operating model from NEOSEC and a registered trademark of NEOSEC GmbH. It extends classic SIEM — the central collection, normalisation and correlation of security-relevant events — with endpoint forensics, network visibility and deception technology, and consolidates them into three building tiers: Sentry, Orchestrate and Command.
Read in glossary- 5.9 Methodology
CVSS v3
CVSS is the globally established, open standard for assessing the technical severity of a vulnerability on a scale from 0 to 10. It describes how easily a flaw can be exploited and what damage it can cause — but not how likely its actual exploitation is. CVSS and the complementary EPSS deliberately answer different questions.
Read in glossary- 5.9
EPSS score
The EPSS score is the absolute model output for an individual vulnerability: the estimated probability of real-world exploitation within the next 30 days, expressed as a value between 0 and 1 (i.e. 0 % to 100 %). A score of 0.42 means „the model estimates a 42 % chance of real-world exploitation within 30 days“.
Read in glossary- 0.2 %
- Low — model estimates < 1% exploitation likelihood.
EPSS percentile
The EPSS percentile is the relative position of a vulnerability within all EPSS-scored CVEs, expressed as a value between 0 and 1. A percentile of 0.90 means „this CVE has a higher EPSS score than 90 % of all other scored CVEs“. Unlike the EPSS score, it is not a probability — but a positioning within a ranking.
Read in glossary- 13.9
- Elevated — this CVE ranks above at least 10% of all CVEs scored today.
KEV status
The KEV catalogue is a list maintained by the US authority CISA of vulnerabilities for which active exploitation in the wild has been confirmed. It answers not the question „how severe?“ but „is it already being attacked?“ — thereby sharply prioritising patching.
Read in glossary- —
- Published
- CISA assessment (SSVC)
- Exploitation: none known · not automatable · Technical impact: partial
- Source: CISA Vulnrichment, as of 16 October 2026
CWE
CWE is a catalogue of typical weakness types in software and hardware — such as flawed input validation, unsafe memory handling or poor authentication. Where a CVE names a concrete vulnerability in a concrete product, a CWE describes the underlying class of defect.
Read in glossary- CWE-191
Detection rules
No NEOSEC detection rule is available for this vulnerability yet.
Classification under NIS2 and CRA
Rule-based classification from exploitation status and severity. It does not replace a case-by-case assessment.
NIS2
NIS2 is EU Directive (EU) 2022/2555 to raise the level of cybersecurity across the Union. It substantially broadens obligations compared with the first NIS directive: more sectors, mandatory risk management, staged reporting duties and personal accountability of senior management.
Read in glossary- Handle the vulnerability in regular vulnerability handling under Art. 21(2)(e) NIS2.
CRA
The CRA is EU Regulation (EU) 2024/2847 setting horizontal cybersecurity requirements for „products with digital elements“ — from industrial controllers and software to connected consumer devices. For the first time manufacturers must ensure security across the entire product lifecycle, handle vulnerabilities and provide security updates.
Read in glossary- From 11.12.2027, Annex I Part II CRA requires manufacturers of affected products with digital elements to handle vulnerabilities without delay and provide security updates.
ISO/IEC 27001
ISO/IEC 27001 is the internationally leading standard for an information security management system (ISMS). It describes a risk-based, process-oriented framework to systematically plan, implement, review and improve information security.
Read in glossary- Control A.8.8, management of technical vulnerabilities: assess relevance to your systems, plan remediation and keep evidence.
Description
The receive path of the NXP KW41Z IEEE 802.15.4 driver, kw41z_rx() in drivers/ieee802154/ieee802154_kw41z.c, computed the payload size as pkt_len = len - KW41Z_FCS_LENGTH in a uint8_t, where len is the frame length reported by the radio. The interrupt handler kw41z_isr() obtained that length from the RX_FRAME_LENGTH field of the ZLL IRQSTS register — a copy of the PHY header length byte of the frame received over the air — and only rejected the value zero. A reported length of one therefore underflowed to pkt_len == 255. Because the packet is allocated with NET_AF_UNSPEC on a non-Ethernet L2, net_pkt_rx_alloc_with_buffer() does not clamp the request to the interface MTU; with the default fixed-size buffer pool (CONFIG_NET_BUF_FIXED_DATA_SIZE, CONFIG_NET_BUF_DATA_SIZE=128) the allocation succeeded as a chain of two fragments. The subsequent register-to-buffer copy loops write into the first fragment only, so 255 bytes were written into a 128-byte net_buf data block, overrunning it by up to 127 bytes into adjacent network-buffer-pool memory, and reading up to 128 bytes past the end of the radio's PKT_BUFFER_RX register array. The length field originates from an unauthenticated frame transmitted by any device within 802.15.4 radio range, and is captured by the hardware at PHY-header time — before frame filtering has completed — while the handler samples it after clearing the interrupt status, so an attacker flooding frames with a length byte of one can drive the underflow. The impact is memory corruption in the shared receive buffer pool from interrupt context, most plausibly a crash or corruption of other packets' data; the overflowing bytes are radio register contents rather than attacker-authored data, which bounds the integrity impact. The fix rejects any length below KW41Z_FCS_LENGTH and additionally verifies net_buf_tailroom() of the first fragment before the copy loops, which also covers the CONFIG_NET_L2_OPENTHREAD variant of the size computation.
Source: cvelistv5, NVD (NIST)
Affected products
The following versions are affected. Older releases of the same product line are also vulnerable unless stated otherwise.
| Affected versions | Fixed in | ||
|---|---|---|---|
| zephyrproject | zephyr |
|
|
Vendors and products
Weakness classes (CWE)
CWE-191Integer Underflow (Wrap or Wraparound)
Base
The product subtracts one value from another, such that the result is less than the minimum allowable integer value, which produces a value that is not equal to the correct result.
Entry at MITRE CWE-191
References & sources
- github.comFix commitPatch
- github.comGHSA-2pwx-gg6f-535f
Changes to this CVE
Who changed this CVE and when: NVD (analysis, affected products, CVSS), the CVE publisher (CNA) and additional providers such as CISA (ADP).
Record modifiedzephyrproject.org
1 individual change: Affected versions (publisher)
Show the original change
Individual changes of this event as published by NVD Type Action Before After Affected versions (publisher) added —Affected value modified. <a href="https://github.com/CVEProject/cvelistV5/blob/main/cves/2026/75xxx/CVE-2026-75083.json">CVE-2026-75083</a>Source identifier: vulnerabilities@zephyrproject.org
Record modifiedCISA ADP
CISA assessment (SSVC): exploitation: none known, automatable: no
Show the original change
Individual changes of this event as published by NVD Type Action Before After SSVC assessment added —{"id":"CVE-2026-75083","role":"CISA Coordinator","options":[{"exploitation":"none"},{"automatable":"no"},{"technicalImpact":"partial"}],"version":"2.0.3","timestamp":"2026-10-16T15:25:03.202886Z"}Source identifier: 134c704f-9b21-4f2e-91b3-4a467353bcc0
Receivedzephyrproject.org
CVSS V3.1: AV:A/AC:H/PR:N/UI:N/S:U/C:N/I:L/A:H
Weakness type: CWE-191
Description added or changed
Show 6 original changes
Individual changes of this event as published by NVD Type Action Before After Description added —The receive path of the NXP KW41Z IEEE 802.15.4 driver, kw41z_rx() in drivers/ieee802154/ieee802154_kw41z.c, computed the payload size as pkt_len = len - KW41Z_FCS_LENGTH in a uint8_t, where len is the frame length reported by the radio. The interrupt handler kw41z_isr() obtained that length from the RX_FRAME_LENGTH field of the ZLL IRQSTS register — a copy of the PHY header length byte of the frame received over the air — and only rejected the value zero. A reported length of one therefore underflowed to pkt_len == 255. Because the packet is allocated with NET_AF_UNSPEC on a non-Ethernet L2, net_pkt_rx_alloc_with_buffer() does not clamp the request to the interface MTU; with the default fixed-size buffer pool (CONFIG_NET_BUF_FIXED_DATA_SIZE, CONFIG_NET_BUF_DATA_SIZE=128) the allocation succeeded as a chain of two fragments. The subsequent register-to-buffer copy loops write into the first fragment only, so 255 bytes were written into a 128-byte net_buf data block, overrunning it by up to 127 bytes into adjacent network-buffer-pool memory, and reading up to 128 bytes past the end of the radio's PKT_BUFFER_RX register array. The length field originates from an unauthenticated frame transmitted by any device within 802.15.4 radio range, and is captured by the hardware at PHY-header time — before frame filtering has completed — while the handler samples it after clearing the interrupt status, so an attacker flooding frames with a length byte of one can drive the underflow. The impact is memory corruption in the shared receive buffer pool from interrupt context, most plausibly a crash or corruption of other packets' data; the overflowing bytes are radio register contents rather than attacker-authored data, which bounds the integrity impact. The fix rejects any length below KW41Z_FCS_LENGTH and additionally verifies net_buf_tailroom() of the first fragment before the copy loops, which also covers the CONFIG_NET_L2_OPENTHREAD variant of the size computation.CVSS added —AV:A/AC:H/PR:N/UI:N/S:U/C:N/I:L/A:HWeakness type (CWE) added —CWE-191Affected versions (publisher) added —New affected value received. <a href="https://github.com/CVEProject/cvelistV5/blob/main/cves/2026/75xxx/CVE-2026-75083.json">CVE-2026-75083</a>Reference added —https://github.com/zephyrproject-rtos/zephyr/commit/51d71864578c08eb1a1201f87b46ec81c8609d62Reference added —https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-2pwx-gg6f-535fSource identifier: vulnerabilities@zephyrproject.org
Embed badge
Show the severity and KEV status of this vulnerability on your site – with a link back here. The image is updated hourly.
<a href="https://intel.neosec.eu/en/cve/CVE-2026-75083"><img src="https://intel.neosec.eu/badge/cve/CVE-2026-75083.svg?lang=en" alt="CVE-2026-75083 – NEOSEC Intel" height="20"></a>