Unchecked serial-recovery image index causes out-of-bounds slot-table read in MCUboot Zephyr port (CVE-2026-16664)
Published Last modified Sources: CVE.org, EUVD
What is affected, what to do
MCUboot's Zephyr serial-recovery upload handler bs_upload() in boot/boot_serial/src/boot_serial.c decodes the host-supplied image field of an MCUmgr image-upload request into img_num (a full 32-bit value) and latches it on the off == 0 packet without any range check. It then passes img_num straight to flash_area_id_from_multi_image_slot(img_num, 0), which on the Zephyr port resolves to __flash_area_ids_for_slot() in boot/zephyr/include/sysflash/sysflash.h and indexes the static const int all_slots[] table as all_slots[img_num 2].
The available sources name no fixed version. Check the vendor guidance in the references below.
- Affected
- Mcu-tools Mcuboot
gte 2.0.0..*
- Mcu-tools Mcuboot
Not sure whether and how you are affected? Ask a question about this vulnerability
Metrics
5.1
XIEM Effective CVSS
Highest available CVSS rating from NVD and vendor data.
Source: Vendor (CNA), CVSS v3
5.1
CVSS v3
Severity Medium on the scale from 0 to 10.
Source: CVE.org, EUVD
—
EPSS score
No value is available for this vulnerability.
Show all metrics
- Severity
- Medium
Priority (0–325)
The priority score is a consolidated metric that condenses several individual signals into a single, action-guiding ranking: technical severity (CVSS), exploitation likelihood (EPSS), known-exploited status (KEV) and the context of the affected asset. The aim is to answer the only truly important question in vulnerability management: what first?
Read in glossary- 55.50 Methodology
Exploit maturity
An exploit is code or a technique that specifically uses a concrete vulnerability to force unintended behaviour — such as executing code or escalating privileges. It is the tool that turns a theoretical flaw into a practical attack.
Read in glossary- no public PoC known
XIEM Effective CVSS
XIEM® is the tiered managed-security operating model from NEOSEC and a registered trademark of NEOSEC GmbH. It extends classic SIEM — the central collection, normalisation and correlation of security-relevant events — with endpoint forensics, network visibility and deception technology, and consolidates them into three building tiers: Sentry, Orchestrate and Command.
Read in glossary- 5.1 Methodology
CVSS v3
CVSS is the globally established, open standard for assessing the technical severity of a vulnerability on a scale from 0 to 10. It describes how easily a flaw can be exploited and what damage it can cause — but not how likely its actual exploitation is. CVSS and the complementary EPSS deliberately answer different questions.
Read in glossary- 5.1
KEV status
The KEV catalogue is a list maintained by the US authority CISA of vulnerabilities for which active exploitation in the wild has been confirmed. It answers not the question „how severe?“ but „is it already being attacked?“ — thereby sharply prioritising patching.
Read in glossary- —
- Published
CWE
CWE is a catalogue of typical weakness types in software and hardware — such as flawed input validation, unsafe memory handling or poor authentication. Where a CVE names a concrete vulnerability in a concrete product, a CWE describes the underlying class of defect.
Read in glossary- CWE-129
Detection rules
No NEOSEC detection rule is available for this vulnerability yet.
Classification under NIS2 and CRA
Rule-based classification from exploitation status and severity. It does not replace a case-by-case assessment.
NIS2
NIS2 is EU Directive (EU) 2022/2555 to raise the level of cybersecurity across the Union. It substantially broadens obligations compared with the first NIS directive: more sectors, mandatory risk management, staged reporting duties and personal accountability of senior management.
Read in glossary- Handle the vulnerability in regular vulnerability handling under Art. 21(2)(e) NIS2.
CRA
The CRA is EU Regulation (EU) 2024/2847 setting horizontal cybersecurity requirements for „products with digital elements“ — from industrial controllers and software to connected consumer devices. For the first time manufacturers must ensure security across the entire product lifecycle, handle vulnerabilities and provide security updates.
Read in glossary- From 11.12.2027, Annex I Part II CRA requires manufacturers of affected products with digital elements to handle vulnerabilities without delay and provide security updates.
ISO/IEC 27001
ISO/IEC 27001 is the internationally leading standard for an information security management system (ISMS). It describes a risk-based, process-oriented framework to systematically plan, implement, review and improve information security.
Read in glossary- Control A.8.8, management of technical vulnerabilities: assess relevance to your systems, plan remediation and keep evidence.
Description
MCUboot's Zephyr serial-recovery upload handler bs_upload() in boot/boot_serial/src/boot_serial.c decodes the host-supplied image field of an MCUmgr image-upload request into img_num (a full 32-bit value) and latches it on the off == 0 packet without any range check. It then passes img_num straight to flash_area_id_from_multi_image_slot(img_num, 0), which on the Zephyr port resolves to __flash_area_ids_for_slot() in boot/zephyr/include/sysflash/sysflash.h and indexes the static const int all_slots[] table as all_slots[img_num 2]. That table holds only MCUBOOT_IMAGE_NUMBER 2 entries, so any img_num >= MCUBOOT_IMAGE_NUMBER is an out-of-bounds read. The path is reachable by anyone with access to the serial / SMP recovery console, which is unauthenticated by design, and the bad value is supplied before any image signature is verified. The defect is specific to the default non-direct upload path (MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD disabled) on the Zephyr port with the array-backed slot layout (not CONFIG_SINGLE_APPLICATION_SLOT). It is not gated on a multi-image configuration: MCUBOOT_IMAGE_NUMBER defaults to 1, so even a default single-image build is affected for any image >= 1. The MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD path is safe (its flash_area_id_from_direct_image() switch returns -EINVAL for unknown indices). flash_area_id_from_multi_image_slot() takes a signed int image_index while img_num is uint32_t, so the attacker controls the sign of the index as well as its magnitude: an image of 0xFFFFFFFF converts to -1 and reads all_slots[-2], off the front of the table, while large positive values read off the end (CWE-192). Either way the index multiply img * 2 is performed in int, so a wild offset yields a bus/hard fault, giving a reliable denial of service of the bootloader during recovery. For moderately out-of-range indices the read returns adjacent .rodata as a garbage flash-area id that is handed to flash_area_open(); this normally fails with MGMT_ERR_EINVAL, but if the garbage id happens to match a valid non-image partition, the subsequent erase/write can target a partition outside the image set (CWE-787). The attacker-supplied value is never echoed back, so there is no information disclosure. The fix is to reject img_num >= BOOT_IMAGE_NUMBER on the off == 0 packet, before the slot lookup. The comparison must be made on the unsigned img_num: an equivalent guard applied after the conversion to int would not reject the negative case above. __flash_area_ids_for_slot() should bounds-check its own arguments as defence in depth. This vulnerability was reported independently twice: by NVIDIA Project Vanessa on 2026-06-22, and by Kai Phan (@kaimandalic) on 2026-07-19 as GHSA-8v33-88p6-jffj, which is closed as a duplicate of this advisory. Both original reports are reproduced in full below.
Source: NVD (NIST), ENISA EUVD, cvelistv5
Affected products
The following versions are affected. Older releases of the same product line are also vulnerable unless stated otherwise.
| Affected versions | Fixed in | ||
|---|---|---|---|
| mcu-tools | mcuboot |
|
|
Vendors and products
Weakness classes (CWE)
CWE-129Improper Validation of Array Index
Variant
The product uses untrusted input when calculating or using an array index, but the product does not validate or incorrectly validates the index to ensure the index references a valid position within the array.
Entry at MITRE CWE-129
References & sources
- github.comFix commiteuvd, Patch
- github.comGHSA-8rcq-2mgr-fhp8euvd
- NVD (NIST)vuln/detail/CVE-2026-16664euvd
Changes to this CVE
Who changed this CVE and when: NVD (analysis, affected products, CVSS), the CVE publisher (CNA) and additional providers such as CISA (ADP).
Receivedzephyrproject.org
CVSS V3.1: AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:L/A:L
Weakness type: CWE-129
Description added or changed
Show 6 original changes
Individual changes of this event as published by NVD Type Action Before After Description added —MCUboot's Zephyr serial-recovery upload handler bs_upload() in boot/boot_serial/src/boot_serial.c decodes the host-supplied image field of an MCUmgr image-upload request into img_num (a full 32-bit value) and latches it on the off == 0 packet without any range check. It then passes img_num straight to flash_area_id_from_multi_image_slot(img_num, 0), which on the Zephyr port resolves to __flash_area_ids_for_slot() in boot/zephyr/include/sysflash/sysflash.h and indexes the static const int all_slots[] table as all_slots[img_num 2]. That table holds only MCUBOOT_IMAGE_NUMBER 2 entries, so any img_num >= MCUBOOT_IMAGE_NUMBER is an out-of-bounds read. The path is reachable by anyone with access to the serial / SMP recovery console, which is unauthenticated by design, and the bad value is supplied before any image signature is verified. The defect is specific to the default non-direct upload path (MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD disabled) on the Zephyr port with the array-backed slot layout (not CONFIG_SINGLE_APPLICATION_SLOT). It is not gated on a multi-image configuration: MCUBOOT_IMAGE_NUMBER defaults to 1, so even a default single-image build is affected for any image >= 1. The MCUBOOT_SERIAL_DIRECT_IMAGE_UPLOAD path is safe (its flash_area_id_from_direct_image() switch returns -EINVAL for unknown indices). flash_area_id_from_multi_image_slot() takes a signed int image_index while img_num is uint32_t, so the attacker controls the sign of the index as well as its magnitude: an image of 0xFFFFFFFF converts to -1 and reads all_slots[-2], off the front of the table, while large positive values read off the end (CWE-192). Either way the index multiply img * 2 is performed in int, so a wild offset yields a bus/hard fault, giving a reliable denial of service of the bootloader during recovery. For moderately out-of-range indices the read returns adjacent .rodata as a garbage flash-area id that is handed to flash_area_open(); this normally fails with MGMT_ERR_EINVAL, but if the garbage id happens to match a valid non-image partition, the subsequent erase/write can target a partition outside the image set (CWE-787). The attacker-supplied value is never echoed back, so there is no information disclosure. The fix is to reject img_num >= BOOT_IMAGE_NUMBER on the off == 0 packet, before the slot lookup. The comparison must be made on the unsigned img_num: an equivalent guard applied after the conversion to int would not reject the negative case above. __flash_area_ids_for_slot() should bounds-check its own arguments as defence in depth. This vulnerability was reported independently twice: by NVIDIA Project Vanessa on 2026-06-22, and by Kai Phan (@kaimandalic) on 2026-07-19 as GHSA-8v33-88p6-jffj, which is closed as a duplicate of this advisory. Both original reports are reproduced in full below.CVSS added —AV:L/AC:L/PR:N/UI:N/S:U/C:N/I:L/A:LWeakness type (CWE) added —CWE-129Affected versions (publisher) added —New affected value received. <a href="https://github.com/CVEProject/cvelistV5/blob/main/cves/2026/16xxx/CVE-2026-16664.json">CVE-2026-16664</a>Reference added —https://github.com/mcu-tools/mcuboot/commit/183a05f256bdbbac86edcb048958da59018f814eReference added —https://github.com/mcu-tools/mcuboot/security/advisories/GHSA-8rcq-2mgr-fhp8Source identifier: vulnerabilities@zephyrproject.org
Embed badge
Show the severity and KEV status of this vulnerability on your site – with a link back here. The image is updated hourly.
<a href="https://intel.neosec.eu/en/cve/CVE-2026-16664"><img src="https://intel.neosec.eu/badge/cve/CVE-2026-16664.svg?lang=en" alt="CVE-2026-16664 – NEOSEC Intel" height="20"></a>